Dell Z9500 Command Reference Manual page 1401

group-address
source-address
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
8.1.1.0
7.8.1.0
Usage The following describes the show ip pim tib command shown in the following
Information example.
Field
(S, G)
uptime
expires
RP
flags
PIM-Sparse Mode (PIM-SM)
(OPTIONAL) Enter the group address in dotted decimal
format (A.B.C.D).
(OPTIONAL) Enter the source address in dotted decimal
format (A.B.C.D).
EXEC
EXEC Privilege
Description
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Description
Displays the entry in the multicast PIM database.
Displays the amount of time the entry has been in the PIM
route table.
Displays the amount of time until the entry expires and is
removed from the database.
Displays the IP address of the RP/source for this entry.
List the flags to define the entries:
• D = PIM Dense Mode
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
1401