Lacp Ungroup Member-Independent - Dell Z9500 Command Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
Parameter
Enter the value (in seconds) to specify the time interval for delay restore timer to
abort. This timer is applicable only during reload/boot-up and not in other
scenarios (example, ICL flap).
The range is from 1 to 1800 seconds.
Usage To abort VLT delay restore timer as the maximum threshold, the maximum time
Information interval is applied to hold down ICL peer-up in the start-up configurations during
the reload.

lacp ungroup member-independent

Prevent possible loop during the bootup of a VLT peer switch or a device that accesses the VLT domain.
Syntax
lacp ungroup member-independent {vlt | port-channel}
Parameters
port-channel
vlt
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
9.2(0.0)
1854
Description
Introduced on the S4820T, S4810, S6000, S5000, Z9000,
S6000–ON and Z9500.
Force all LACP port-channel members to become
switchports.
Force all VLT LACP members to become switchports.
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Virtual Link Trunking (VLT)