Policy-Map-Output - Dell Z9500 Command Reference Manual

Related
service-queue
Commands
policy-aggregate
using policy maps.
service-policy input

policy-map-output

Create an output policy map.
Z9500
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
Parameters
policy-map-
name
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
7.6.1.0
6.1.1.1
Usage To assign traffic to different flows using QoS policy, use the Output Policy map.
Information This command enables Policy-Map-Output Configuration mode (conf-policy-
map-out).
Related
service-queue
Commands
1500
— assigns a class map and QoS policy to different queues.
— allows an aggregate method of configuring per-port QoS
— applies an input policy map to the selected interface.
Enter the name for the policy map in character format (32
characters maximum).
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Policy name character limit increased from 16 to 32.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
— assigns a class map and QoS policy to different queues.
Quality of Service (QoS)