Dell Z9500 Command Reference Manual page 1559

Hide thumbs Also See for Z9500:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

If you change the timers on one router, also synchronize the timers on all routers

in the RIP domain.

Routing Information Protocol (RIP)

Enter the number of seconds to specify a time interval during

which the route is marked as unreachable but still sending

RIP packets. The holddown value should be at least three

times the update timer value. The range is from zero (0) to

4294967295. The default is 180 seconds.

Enter the number of seconds to specify the time interval

during which the route is advertised as unreachable. When

this interval expires, the route is flushed from the routing

table. The flush value should be greater than the update

value. The range is from zero (0) to 4294967295. The default

is 240 seconds.

update = 30 seconds

invalid = 180 seconds

holddown = 180 seconds

flush = 240 seconds

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.