Show Running-Config Ecmp-Group - Dell Z9500 Command Reference Manual

show running-config ecmp-group

Display interfaces, LAG, or LAG link bundles being monitored for uneven traffic distribution using the
ecmp-group monitoring enable command. The ECMP group could have a LAG or a list of 10G/40
interfaces (not just LAG link-bundles).
Z9500
Syntax
show running-config ecmp-group
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.10.0
Related ecmp-group
Commands
shutdown
Disable an interface.
Z9500
Syntax
shutdown
To activate an interface, use the no shutdown command.
Defaults The interface is disabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Interfaces
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
— configures a mechanism to monitor traffic distribution.
883