Ntp Source - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

You can configure multiple time-serving hosts (up to 250). From these time-

serving hosts, the system chooses one NTP host with which to synchronize. To

determine which server was selected, use the show ntp associations

Because many polls to NTP hosts can impact network performance, Dell

Networking recommends limiting the number of hosts configured.

show ntp associations

ntp source

Specify an interface's IP address to be included in the NTP packets.

ntp source interface

To delete the configuration, use the no ntp source command.

Not configured.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

Introduced on the E-Series.

— displays the NTP servers configured and their status.

Enter the following keywords and slot/port or number

information:

For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16383.

For a Port Channel interface, enter the keyword lag then

a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

System Time and Date