Protocol Lldp (Configuration) - Dell Z9500 Command Reference Manual

Version
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.4.1.0

protocol lldp (Configuration)

Enable the LLDP globally on the switch.
Z9500
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults Enabled.
Command CONFIGURATION (conf-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.4.1.0
protocol lldp (Interface)
Enter the LLDP protocol in INTERFACE mode.
Z9500
Syntax
[no] protocol lldp
Link Layer Discovery Protocol (LLDP)
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1185