rate-limit
Configure the rate-limit to limit the mirrored packets.
Syntax
rate-limit limit
To remove the limit, use the no rate-limit limit command.
Parameters
limit
Defaults
60
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.8(0.0)
Related
monitor session
Commands
show monitor session
show config
Display the current monitor session configuration.
Z9500
Syntax
show config
Defaults
none
Command
MONITOR SESSION (conf-mon-sess-session-ID)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Port Monitoring
Enter the rate-limit value. The range is from 0 to 40000
Megabits per second.
Description
Introduced on the S4810, S4820T, S5000, S6000, S6000-
ON, Z9500.
— enables a monitoring session.
— displays the monitor session.
1439