Ipv6 Access-List - Dell Z9500 Command Reference Manual

ipv6 access-list

Configure an access list based on IPv6 addresses or protocols.
Z9500
Syntax
ipv6 access-list access-list-name
To delete an access list, use the no ipv6 access-list access-list-name
command.
Parameters
access-list-
name
Defaults All access lists contain an implicit "deny any"; that is, if no match occurs, the packet
is dropped.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.7.0
8.4.2.1
8.2.1.0
7.8.1.0
7.4.1.0
Usage The number of entries allowed per ACL is hardware-dependent. For detailed
Information specification on entries allowed per ACL, refer to your line card documentation.
Related show config
Commands
IPv6 Access Control Lists (IPv6 ACLs)
Enter the access list name as a string, up to 140 characters.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the E-Series ExaScale.
Introduced on the C-Series. Increased the name string to
accept up to 140 characters. Prior to version 7.8.1.0, names
are up to 16 characters long.
Introduced on the E-Series TeraScale.
— views the current configuration.
1001