Maximum-Paths - Dell Z9500 Command Reference Manual

Version
8.3.12.0
8.3.11.1
Usage
Change the maximum LSP lifetime with this command. The maximum LSP lifetime
Information
must always be greater than the LSP refresh interval.
The seconds parameter enables the router to keep LSPs for the specified length of
time. If the value is higher, the overhead is reduced on slower-speed links.
Related lsp-refresh-interval
Commands

maximum-paths

Allows you to configure the maximum number of equal cost paths allowed in a routing table.
Z9500
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths command.
Parameters
number
Defaults 4
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.0.2.0
8.3.19.0
Intermediate System to Intermediate System (IS-IS)
Description
Introduced on the S4810.
Introduced on the Z9000.
— sets the link-state packet (LSP) refresh interval.
Enter a number as the maximum number of parallel paths an
IP routing installs in a routing table. The range is from 1 to 16.
The default is 4.
ROUTER ISIS (for IPv4)
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Description
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
1101