Redirect - Dell Z9500 Command Reference Manual

operator
Defaults none
Command REDIRECT-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.4(0.0)
8.4.2.1
8.4.2.0
7.5.1.0

redirect

Configure a rule for the redirect list.
Z9500
Syntax
redirect {ip-address | slot/port} | tunnel tunnel-id}[track
<obj-id>]{ip-protocol-number | protocol-type [bit]} {source
Policy-based Routing (PBR)
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
(OPTIONAL) For TCP and UDP parameters only. Enter one of
the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two
ports for the portcommand parameter.)
Description
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, and Z9000.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.
Introduced on the E-Series ExaScale.
1427