Ip Ospf Dead-Interval - Dell Z9500 Command Reference Manual

ip ospf dead-interval

Set the time interval since the last hello-packet was received from a router. After the interval elapses, the
neighboring routers declare the router dead.
Z9500
Syntax
ip ospf dead-interval seconds
To return to the default values, use the no ip ospf dead-interval command.
Parameters
seconds
Defaults 40 seconds
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.1.1.1
Usage By default, the dead interval is four times the default hello-interval.
Information
Related ip ospf hello-interval
Commands
ip ospf hello-interval
Specify the time interval between the hello packets sent on the interface.
Z9500
Syntax
ip ospf hello-interval seconds
1278
Enter the number of seconds for the interval. The range is
from 1 to 65535. The default is 40 seconds.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— sets the time interval between the hello packets.
Open Shortest Path First (OSPFv2 and OSPFv3)