Ipv6 Host - Dell Z9500 Command Reference Manual

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Usage If the flowlabel value is already set for BGP or SSH, the system defaults to the
Information already configured value. All packets on the same connection are considered part
of the same flow by the system. For new connections, set the new flowlabel to
zero.

ipv6 host

Assign a name and IPv6 address the host-to-IPv6 address mapping table uses.
Z9500
Syntax
ipv6 host name ipv6-address
To remove an IP host, use the no ipv6 host name {ipv6–address}.
Parameters
name
ipv6-address
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
IPv6 Basics
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Enter a text string to associate with one IP address.
Enter the IPv6 address (X:X:X:X::X) to be mapped to the
name.
1019