Channel-Member - Dell Z9500 Command Reference Manual

NOTE: The implementation of LAG or Port Channel requires that you configure a LAG on both
switches manually. For information about the link aggregation control protocol (LACP) for dynamic
LAGs, refer to the
configuring and using Port Channels, refer to the Dell Networking OS Configuration Guide.

channel-member

Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
Z9500
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member
interface command.
Parameters
interface
Defaults Not configured.
Command INTERFACE PORTCHANNEL
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.2.1.0
892
Link Aggregation Control Protocol (LACP)
(OPTIONAL) Enter any of the following keywords and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
chapter. For more information about
Interfaces