To delete a filter, use the no seq sequence-number command.
Parameters
sequence-
number
permit
redirect
ip-address
ip-protocol-
number
tunnel
tunnel-id
track
track <obj-id>
protocol-type
source
mask
any
host ip-address
destination
bit
1430
Enter a number from 1 to 65535.
Enter the keyword permit assign the sequence to the
permit list.
Enter the keyword redirect to assign the sequence to the
redirect list.
Enter the IP address of the forwarding router.
Enter the keyword ip-protocol-number then the number
from 0 to 255 for the protocol identified in the IP protocol
header.
Enter the keyword tunnel to configure the tunnel setting.
Enter the keyword tunnel-idto redirect the traffic.
Enter the keyword track to enable the tracking.
Enter the keyword track <obj-id> to track object-id.
Enter one of the following keywords as the protocol type:
•
icmp for internet control message protocol
•
ip for any internet protocol
•
tcp for transmission control protocol
•
udp for user datagram protocol
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x).
Enter the keyword any to specify that all traffic is subject to
the filter.
Enter the keyword host then the IP address to specify a host
IP address.
Enter the IP address of the network or host to which the
packets are sent.
(OPTIONAL) For the TCP protocol type only, enter one or a
combination of the following TCP flags:
•
ack = acknowledgement
•
fin = finish (no more data from the user)
•
psh = push function
•
rst = reset the connection
•
syn = synchronize sequence number
•
urg = urgent field
Policy-based Routing (PBR)