Match Ip Access-Group - Dell Z9500 Command Reference Manual

match ip access-group

Configure match criteria for a class map, based on the access control list (ACL).
Z9500
Syntax
match ip access-group access-group-name [set-ip-dscp value]
To remove ACL match criteria from a class map, use the no match ip access-
group access-group-name [set-ip-dscp value] command.
Parameters
access-group-
name
set-ip-dscp
value
Defaults none
Command CLASS-MAP CONFIGURATION (config-class-map)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.5.1.0
7.5.1.0
6.1.1.1
Usage To access this command, enter the class-map command. After the class map is
Information
identified, you can configure the match criteria. For class-map match-any, a
maximum of five ACL match criteria are allowed. For class-map match-all,
only one ACL match criteria is allowed.
Quality of Service (QoS)
Enter the ACL name whose contents are used as the match
criteria in determining if packets belong to the class the
class-map specifies.
(OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the Z9000.
Introduced on the S4810.
Added the DSCP Marking option support on the S-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for the DSCP Marking option.
Introduced on the E-Series.
1491