Hg-Link-Bundle-Monitor Enable - Dell Z9500 Command Reference Manual

Example
Dell# clear hardware linecard 0 hg-stats unit 0 port 59
Dell# show hardware linecard 0 hg-stats unit 0 port 59
Higig Port Statistics:
HiGigabitEthernet 0/0/59,
Input Statistics:
byte pkts
Output Statistics:
byte pkts
7236269947061497449 wredDrops
Rate info (interval 15 seconds):
line-rate
line-rate
Related show hardware hg-stats
Commands link bundle.

hg-link-bundle-monitor enable

Enable the monitoring of link utilization and traffic distribution in backplane HiGig link bundles/port
channels on a line-card or switch fabric module (SFM) NPU.
Z9500
Syntax
hg-link-bundle-monitor {sfm npu-id hg-port—channel hg-port—
channel-id | slot slot npuUnit npu-id hg-port—channel 0} enable
To disable HiGig link-bundle monitoring, use the no version of this command.
Parameters
sfm npu-id hg-
port-channel
hg-port-
channel-id
slot slot-id
npuUnit npu-id
hg-port-
channel 0
enable
Interfaces
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
0 packets, 0 bytes 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-
0 Multicasts, 0 Broadcasts 0 Unicasts
0 throttles, 0 discarded, 8247266722598448750 collisions
Input 00.00 Mbits/sec,
Output 00.00 Mbits/sec,
— displays traffic statistics from internal ports in a HiGig
Specify a HiGig port channel on a Z9500 SFM (spine) NPU by
entering the keyword sfm and SFM NPU ID, then hg-port-
channel and a HiGig port channel ID. SFM NPU IDs are 0 to
5; SFM HiGig port-channel IDs are 0 to 10.
Specify a HiGig port channel on a Z9500 line-card (leaf) NPU
by entering the keyword slot and slot number, then
npuUnit and line-card NPU ID, then hg-port-channel 0.
Line-card slot numbers are 0 to 2; line-card NPU IDs are 0 to
3. The HiGig port-channel ID is always 0 because there is
only one HiGig link bundle on a line-card NPU.
Enable HiGig link-bundle monitoring.
0 packets/sec, 0.00% of
0 packets/sec, 0.00% of
905