Dell Z9500 Command Reference Manual page 902

Parameters
outgoing-port-
channel
number
incoming-
interface
interface
source-ip
address
destination-ip
address
source-port
number
destination-
port number
source-mac
address
destination-
mac address
vlan vlan-id
ether-type
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.10.0
902
Enter the keywords outgoing-port-channel then the
number of the port channel to display flow information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Enter the keywords incoming-interface then the
interface type and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter the keywords source-ip then the IP source address
in IP address format.
Enter the keywords destination-ip then the IP
destination address in IP address format.
Enter the keywords source-port then the source port
number. The range is from 1 to 65536. The default is None.
Enter the keywords destination-port then the
destination port number. The range is from 1 to 65536. The
default is None.
Enter the keywords source-mac then the MAC source
address in the nn:nn:nn:nn:nn:nn format.
Enter the keywords destination-mac then the MAC
destination address in the nn:nn:nn:nn:nn:nn format.
Enter the keywords vlan then the VLAN-id. The range is
from 0 to 4094.
Enter the keywords ether-type in the XX:XX format.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Interfaces