Passive-Interface - Dell Z9500 Command Reference Manual

Version
7.6.1.0
6.2.1.1
Usage This command is intended for low-speed interfaces.
Information

passive-interface

Suppress routing updates on a specified interface.
Z9500
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface
command.
Parameters
interface
Defaults Not configured.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.2(1.0)
9.0.2.0
1550
Description
Introduced on the C-Series.
Introduced on the E-Series.
Enter the following information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 512.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Routing Information Protocol (RIP)