Vlan Bridge-Priority - Dell Z9500 Command Reference Manual

Version
7.5.1.0
6.5.1.0
Usage By default, the system implements an optimized flush mechanism for PVST+. This
Information implementation helps in flushing the MAC addresses only when necessary (and less
often) allowing for faster convergence during topology changes. However, if a
standards-based flush mechanism is needed, you can turn this knob command on
to enable flushing MAC addresses after receiving every topology change
notification.

vlan bridge-priority

Set the PVST+ bridge-priority for a VLAN or a set of VLANs.
Z9500
Syntax
vlan vlan-range bridge-priority value
To return to the default value, use the no vlan bridge-priority command.
Parameters
vlan vlan-range
bridge-priority
value
Defaults 32768
Command CONFIGURATION (conf-pvst)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
1468
Description
Introduced on the C-Series.
Introduced.
Enter the keyword vlan then the VLAN numbers. The range
is from 1 to 4094.
Enter the keywords bridge-priority then the bridge
priority value in increments of 4096. The range is from 0 to
61440. The default is 32768.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Per-VLAN Spanning Tree Plus (PVST+)