Enable - Dell Z9500 Command Reference Manual

Related
•
Commands
•

enable

Enable uplink state group tracking for a specific UFD group.
Z9500
Syntax
enable
To disable upstream-link tracking without deleting the uplink-state group, use the
no enable command.
Defaults Upstream-link tracking is automatically enabled in an uplink-state group.
Command UPLINK-STATE-GROUP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.12.0
8.4.2.3
Related
•
Commands
Uplink Failure Detection (UFD)
downstream — assigns a port or port-channel to the uplink-state group as a
downstream interface.
uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
Description
Introduced on the Z9500.
Introduced on the S4820T
Introduced on the S4810.
Introduced on the S-Series S50.
uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
1819