Advertise Management-Tlv - Dell Z9500 Command Reference Manual

Parameters
max-frame-
size
Defaults none
Command CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.4.1.0

advertise management-tlv

Advertise management TLVs (Type, Length, Value).
Z9500
Syntax
advertise management-tlv {management-address | system-
capabilities | system-description | system-name}
To remove advertised management TLVs, use the no advertise management-
tlv {management-address | system-capabilities | system-
description | system-name} command.
Parameters
management-
address
system-
capabilities
system-
description
system-name
1176
Enter the keywords max-frame-size to advertise the dot3
maximum frame size.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the keyword management-address to advertise the
management IP address TLVs to the LLDP peer.
Enter the keywords system-capabilities to advertise the
system capabilities TLVs to the LLDP peer.
Enter the keywords system-description to advertise the
system description TLVs to the LLDP peer.
Enter the keywords system-name to advertise the system
name TLVs to the LLDP peer.
Link Layer Discovery Protocol (LLDP)