output-range
interface
vlan vlan-id
Defaults
Not configured.
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.2(1.0)
9.0.2.0
9.1(0.0)
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
7.6.1.0
7.5.1.0
pre-6.2.1.1
Example
mac-address-table static 00:01:00:00:00:01 {output Te 1/2 vlan
(Unicast)
2}
1140
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 512.
For a multicast MAC address, enter the keyword output-
range then one of the following interfaces to indicate a
range of ports for which traffic is forwarded:
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a port channel interface, enter the keywords port-
channel then a number.
Enter the keyword vlan then a VLAN ID number from 1 to
4094.
Description
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Added support for output range parameter for S4810 and
Z9000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Layer 2