Ipv6 Ospf Area - Dell Z9500 Command Reference Manual

ipv6 ospf area

Enable IPv6 OSPF on an interface.
Z9500
Syntax
ipv6 ospf process id areaarea id
To disable OSPFv6 routing for an interface, use the no ipv6 ospf process-id
area area-id command.
Parameters
process-id
area area-id
Defaults none
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.1.(0.0)
8.3.19.0
7.4.1.0
ipv6 ospf authentication
Configure an IPsec authentication policy for OSPFv3 packets on an IPv6 interface.
Z9500
Syntax
ipv6 ospf authentication {null | ipsec spi number {MD5 | SHA1}
[key-encryption-type] key}}
Parameters
null
ipsec spi
number
MD5 | SHA1
1344
Enter the process identification number.
Specify the OSPF area. The range is from 0 to 65535.
Description
Introduced on the Z9500.
Introduced on the S4810 and Z9000.
Introduced on the S4820T.
Introduced on the E-Series and C-Series.
Causes an authentication policy configured for the area to
not be inherited on the interface.
Security Policy index (SPI) value that identifies an IPsec
security policy. The range is from 256 to 4294967295.
Authentication type: Message Digest 5 (MD5) or Secure Hash
Algorithm 1 (SHA-1).
Open Shortest Path First (OSPFv2 and OSPFv3)