Ip Radius Source-Interface - Dell Z9500 Command Reference Manual

Version
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.0

ip radius source-interface

Specify an interface's IP address as the source IP address for RADIUS connections.
Z9500
Syntax
ip radius source-interface interface
To delete a source interface, use the no ip radius source-interface
command.
Parameters
interface
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
Security
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the following keywords and slot/port or number
information:
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16838.
• For the Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Description
Introduced on the Z9500.
1629