Speed (Management Interface) - Dell Z9500 Command Reference Manual

Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
Usage
The shutdown command marks a physical interface as unavailable for traffic. To
Information
discover if an interface is disabled, use the show ip interface brief
command. Disabled interfaces are listed as down.
Disabling a VLAN or a port channel causes different behavior. When a VLAN is
disabled, the Layer 3 functions within that VLAN are disabled. Layer 2 traffic
continues to flow. Entering the shutdown command on a port channel disables all
traffic on the port channel and the individual interfaces within the port channel. To
enable a port channel, enter no shutdown on the port channel interface and at
least one interface within that port channel.
The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port channel.
Related
interface port-channel
Commands
interface vlan
show ip interface
to display a table of interfaces and their status.

speed (Management interface)

Set the speed for the Management interface.
Z9500
Syntax
speed {10 | 100 | auto}
To return to the default setting, use the no speed {10 | 100} command.
Parameters
10
100
884
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
— creates a port channel interface.
— creates a VLAN.
— displays the interface routing status. Add the keyword brief
Enter the keyword 10 to set the interface's speed to 10 Mb/s.
Enter the keyword 100 to set the interface's speed to 10/100
Mb/s.
Interfaces