Max-Area-Addresses - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

The refresh interval determines the rate at which route topology information is

transmitted preventing the information from becoming obsolete.

The refresh interval must be less than the LSP lifetime specified with the max-lsp-

lifetime command. A low value reduces the amount of time that undetected link

state database corruption can persist at the cost of increased link utilization. A

higher value reduces the link utilization the flooding of refreshed packets causes.

max-lsp-lifetime

max-area-addresses

Configure manual area addresses.

max-area-addresses number

To return to the default values, use the no max-area-addresses command.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Intermediate System to Intermediate System (IS-IS)

Introduced on the Z9500.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

Added support for LSP Throttling Enhancement.

— sets the maximum interval that LSPs persist without being

Set the maximum number of manual area addresses. The

range is from 3 to 6. The default is 3.