Ip Ssh Connection-Rate-Limit - Dell Z9500 Command Reference Manual

Usage This command specifies the maximum number of attempts to authenticate a user
Information on an SSH connection with the remote host for password authentication. SSH
disconnects when the number of password failures exceeds authentication-retries.

ip ssh connection-rate-limit

Configure the maximum number of incoming SSH connections per minute.
Z9500
Syntax
ip ssh connection-rate-limit 1-10
Parameters
1-10
Defaults 10 per minute
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.1.1.0
ip ssh hostbased-authentication
Enable hostbased-authentication for the SSHv2 server.
Z9500
Syntax
ip ssh hostbased-authentication enable
To disable hostbased-authentication for SSHv2 server, use the no ip ssh
hostbased-authentication enable command.
Security
Enter the number of maximum numbers of incoming SSH
connections allowed per minute. The range is from 1 to 10
per minute. The default is 10 per minute.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1657