Multi-Topology - Dell Z9500 Command Reference Manual

Version
9.0.2.0
8.3.19.0
8.3.11.1
8.3.12.0
Usage
If you enter the metric-style wide command, the Dell Networking OS
Information
generates and accepts only new-style TLVs. The router uses less memory and
other resources rather than generating both old-style and new-style TLVs.
The new-style TLVs have wider metric fields than old-style TLVs.
Related isis metric
Commands

multi-topology

Enables multi-topology IS-IS. It also allows enabling/disabling of old and new style TLVs for IP prefix
information in the LSPs.
Z9500
Syntax
multi-topology [transition]
To return to a single topology configuration, use the no multi-topology
[transition] command.
Parameters
transition
Defaults Disabled
Command CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.0.2.0
Intermediate System to Intermediate System (IS-IS)
Description
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
— configures a metric for an interface.
Description
Introduced on the Z9500.
Introduced on the S6000.
1103