Dell Z9500 Command Reference Manual page 1336

Hide thumbs Also See for Z9500:

Table of Contents

Not configured.

ROUTER OSPFv3

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Before you enable IPsec encryption on an OSPFv3 interface, first enable OSPFv3

globally on the router. Configure the same encryption policy (same SPI and keys)

on each interface in an OSPFv3 link.

An SPI value must be unique to one IPsec security policy (authentication or

encryption) on the router.

When you configure encryption for an OSPFv3 area with the area encryption

command, you enable both IPsec encryption and authentication. However, when

you enable authentication on an area with the area authentication command,

you do not enable encryption at the same time.

If you have enabled IPsec authentication in an OSPFv3 area with the area

authentication command, you cannot use the area encryption command in

the area at the same time.

The configuration of IPsec encryption on an interface-level takes precedence over

an area-level configuration. If you remove an interface configuration, an area

encryption policy that has been configured is applied to the interface.

Valid values: 0 (key is not encrypted) or 7 (key is encrypted).

Text string used in authentication.

For MD5 authentication, the key must be 32 hex digits (non-

encrypted) or 64 hex digits (encrypted).

For SHA-1 authentication, the key must be 40 hex digits

(non-encrypted) or 80 hex digits (encrypted).

Causes an encryption policy configured for the area to not

be inherited on the interface.

Introduced on the Z9500.

Introduced on the S4810 and Z9000.

Introduced on the E-Series TeraScale.

Introduced on the S4820T.

Open Shortest Path First (OSPFv2 and OSPFv3)