Advertise Med Softphone-Voice - Dell Z9500 Command Reference Manual

Version
7.7.1.0
7.6.1.0
Usage Advertise the Extended Power via MDI on all ports that are connected to an 802.3af
Information powered, LLDP-MED endpoint device.
Related
debug lldp interface
Commands
show lldp neighbors
show running-config lldp

advertise med softphone-voice

To advertise softphone to enable IP telephony on a computer so that the computer can be used as a
phone, configure the system.
Z9500
Syntax
advertise med softphone-voice {vlan-id layer2_priority
DSCP_value} | {priority-tagged number}
To return to the default, use the no advertise med softphone-voice
{vlan-id layer2_priority DSCP_value} | {priority-tagged number}
command.
Parameters
vlan-id
layer2_priority
DSCP_value
priority-tagged
number
Defaults unconfigured.
Command CONFIGURATION (conf-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
1194
Description
Introduced on the S-Series.
Introduced on the C-Series.
— debugs LLDP.
— displays the LLDP neighbors.
— displays the LLDP running configuration.
Enter the VLAN ID. The range is from 1 to 4094.
Enter the Layer 2 priority (C-Series and E-Series only). The
range is from 0 to 7.
Enter the DSCP value (C-Series and E-Series only). The range
is from 0 to 63.
Enter the keywords priority-tagged then the Layer 2
priority. The range is from 0 to 7.
Description
Introduced on the Z9500.
Link Layer Discovery Protocol (LLDP)