Max-Lsp-Lifetime - Dell Z9500 Command Reference Manual

Version
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
7.5.1.0
Usage To configure the number of area addresses on router, use this command. This
Information value must be consistent with routers in the same area, otherwise the router forms
only Level 2 adjacencies. The value must be same among all the routers to form
Level 1 adjacencies.

max-lsp-lifetime

Set the maximum time that link-state packets (LSPs) exist without being refreshed.
Z9500
Syntax
max-lsp-lifetime seconds
To restore the default time, use the no max-lsp-lifetime command.
Parameters
seconds
Defaults 1200 seconds
Command ROUTER ISIS
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.0.2.0
8.3.19.0
1100
Description
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Added support for LSP Throttling Enhancement.
The maximum lifetime of LSP in seconds. This value must be
greater than the lsp-refresh-interval command. The
higher the value the longer the LSPs are kept. The range is
from 1 to 65535. The default is 1200.
Description
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Intermediate System to Intermediate System (IS-IS)