When you enter the switchport command, the interface is automatically added
to the default VLAN.
To use the switchport backup interface command on a port, first enter the
switchport command. For more information, refer to the "Configuring
Redundant Links" section in the "Layer 2" chapter of the Dell Networking OS
Configuration Guide.
Related
interface port-channel
Commands
Egress Interface Selection (EIS) Commands
The following commands are Egress Interface Selection (EIS) commands.
application
Configure the management egress interface selection.
Z9500
Syntax
application {all | application-type}
To remove a management application configuration, use the no application
{all | application-type} command.
Parameters
application-
type
all
Interfaces
— creates a port channel interface.
Enter any of the following keywords:
•
For DNS, enter the keyword dns.
•
For FTP, enter the keyword ftp.
•
For NTP, enter the keyword ntp.
•
For Radius, enter the keyword radius.
•
For sFlow collectors, enter the keyword sflow-
collector.
•
For SNMP (traps and MIB responses), enter the keywords
snmp .
•
For SSH, enter the keyword ssh .
•
For Syslog, enter the keyword syslog.
•
For TACACS, enter the keyword tacacs.
•
For Telnet, enter the keyword telnet.
•
For TFTP, enter the keyword tftp.
Configure all applications.
887