Rate Shape - Dell Z9500 Command Reference Manual

Defaults Granularity for commited-rate and peak-rate is Mbps unless you use the kbps
option.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
7.6.1.0
7.5.1.0
6.1.1.1
Usage
Information
On one interface, you can configure the rate police command for a VLAN or
you can configure the rate police command for an interface. For each physical
interface, you can configure three rate police commands specifying different
VLANS.
Related
rate-police
Commands

rate shape

Shape the traffic output on the selected interface.
Z9500
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps
1484
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added the kbps option on the C-Series, E-Series, and S-
Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: Per Port rate limit and rate police is supported for Layer 2 tagged and
untagged switched traffic and for Layer 3 traffic. Per VLAN rate limit and rate
police is supported on only tagged ports with Layer 2 switched traffic.
— specifies traffic policing on the selected interface.
(Optional) Enter the keyword kbps to specify the rate limit in
kilobits per second (Kbps). The range is from 0 to 10000000.
The default granularity is Megabits per second (Mbps).
Quality of Service (QoS)