Ntp Disable - Dell Z9500 Command Reference Manual

ntp disable

Prevent an interface from receiving NTP packets.
Syntax
ntp disable
To re-enable NTP on an interface, use the no ntp disable command.
Defaults Disabled (that is, if you configure an NTP host, all interfaces receive NTP packets)
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.1.1.0
ntp multicast client
To receive NTP information from the network via multicast, configure the switch.
Z9500
Syntax
ntp multicast client [multicast-address]
To disable multicast reception, use the no ntp multicast client
[multicast-address] command.
Parameters
multicast-
address
System Time and Date
Description
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter a multicast address. Enter either an IPv4
address in dotted decimal format or an IPv6 address in
X:X:X:X::X format. If you do not enter a multicast address, the
address:
1793