Graceful-Restart Mode - Dell Z9500 Command Reference Manual

Parameters
ip-address
Defaults Not configured.
Command ROUTER OSPF
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.12.0
7.8.1.0
7.7.1.0
7.5.1.0
6.1.1.1

graceful-restart mode

Enable the graceful restart mode.
Z9500
Syntax
graceful-restart mode [planned-only | unplanned-only]
To disable graceful restart mode, use the no graceful-restart mode
command.
Parameters
planned-only
unplanned-
only
Defaults Support for both planned and unplanned failures.
Open Shortest Path First (OSPFv2 and OSPFv3)
Enter the OSPF router-id, in IP address format, of the restart
router that will not act as a helper during graceful restart.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Restart role enabled on the S-Series (Both Helper and
Restart roles now supported on S-Series). Added support
for Multi-Process OSPF.
Added Helper-Role support on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter the keywords planned-only to indicate
graceful restart is supported in a planned restart condition
only.
(OPTIONAL) Enter the keywords unplanned-only to
indicate graceful restart is supported in an unplanned restart
condition only.
1273