Reset Linecard - Dell Z9500 Command Reference Manual

Version
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage The output of the show interfaces command displays the configured rate
Information
interval, along with the collected traffic data.
Related show interfaces
Commands

reset linecard

Reset the ports on a Z9500 line card.
Z9500
Syntax
reset linecard slot-id
Parameters
linecard slot-id
Defaults none
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell NetworkingOS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.7.0
8.3.11.1
8.3.1.0
7.8.1.0
Interfaces
Description
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
— displays information on physical and virtual interfaces.
Enter the slot ID number to specify the set of line-card ports
to be reset. The range of Z9500 line-card slot IDs is 0 to 2.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Added the hard reset option.
Augmented to run on the standby unit in order to reset the
standby unit directly.
863