Dell Z9500 Command Reference Manual page 869

Line
Output Statistics:
Rate information...
Time since...
Example
Dell# show interfaces
TenGigabitEthernet 2/0 is down, line protocol is down
Hardware is DellForce10Eth, address is 74:86:7a:ff:6f:18
Pluggable media present, Media type is unknown
Interface index is 151060994
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:08:58
Queueing strategy: fifo
Input Statistics:
Interfaces
Description
– CRC = packets with CRC/FCS errors
– overrun = number of packets discarded due to FIFO
– discarded = the sum of runts, giants, CRC, and
Displays output statistics sent out of the interface including:
• Number of packets, bytes, and underruns out of the
interface
• Packet size and the number of those packets outbound
to the interface
• Number of Multicast, Broadcast, and Unicast packets:
– Multicasts = number of MAC multicast packets
– Broadcasts = number of MAC broadcast packets
– Unicasts = number of MAC unicast packets
• Number of VLANs, throttles, discards, and collisions::
– Vlans = number of VLAN tagged packets
– throttles = packets containing PAUSE frames
– discarded = number of packets discarded without
– collisions = number of packet collisions
– wred=count both packets discarded in the MAC and
Estimate of the input and output traffic rate over a
designated interval (30 to 299 seconds). Traffic rate is
displayed in bits, packets per second, and percent of line
rate.
Elapsed time since the last interface status change
(hh:mm:ss format).
Current address is 74:86:7a:ff:6f:18
Wavelength is 0.00nm
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-
overrun conditions
overrun packets discarded without any processing
any processing
in the hardware-based queues
869