Distance - Dell Z9500 Command Reference Manual

distance

Assign a weight (for prioritization) to all routes in the RIP routing table or to a specific route. Lower
weights ("administrative distance") are preferred.
Z9500
Syntax
distance weight [ip-address mask [prefix-name]]
To return to the default values, use the no distance weight [ip-address
mask] command.
Parameters
weight
ip-address
mask
prefix-name
Defaults weight = 120
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
6.2.1.1
Related default-metric
Commands redistribute command.
1538
Enter a number from 1 to 255 for the weight (for
prioritization). The default is 120.
(OPTIONAL) Enter the IP address, in dotted decimal format
(A.B.C.D), of the host or network to receive the new distance
metric.
If you enter an IP address, also enter a mask for that IP
address, in either dotted decimal format or /prefix format
(/x).
(OPTIONAL) Enter a configured prefix list name.
Description
Introduced on the Z9500.
Introduced on the S4820T
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— assigns one distance metric to all routes learned using the
Routing Information Protocol (RIP)