Test Cam-Usage - Dell Z9500 Command Reference Manual

test cam-usage

Verify that enough ACL CAM space is available for the IPv6 ACLs you have created.
Z9500
Syntax
test cam-usage service-policy input policy-map-name linecard
{slot-id | all}
Parameters
input policy-
map name
linecard slot-id
Defaults none
Command EXEC Privilege
Modes
Command
Version
History
9.2(1.0)
8.2.1.0
7.8.1.0
8.4.2.1
8.2.1.0
7.8.1.0
Usage
This command applies to both IPv4 and IPv6 CAM Profiles, but is best used when
Information
verifying QoS optimization for IPv6 ACLs.
QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a
policy on a single (or the first of several) interfaces. It is most useful when a policy
is applied across multiple interfaces; it can reduce the impact to CAM usage across
subsequent interfaces.
The following describes the test cam-usage command shown in the Example
below.
Term
Linecard
1010
Enter the name of the policy-map to be verified.
Enter the slot ID of the Z9500 line card, which contains the
ports on which you assigned the ACL. Enter all to display
IPv6 ACL information on all line cards. The range of Z9500
slot IDs is from 0 to 2.
Description
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and E-Series TeraScale.
Introduced on the S-Series.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and E-Series TeraScale.
Explanation
Lists the line card or linecards that are checked. Entering
all shows the status for linecards in the chassis.
IPv6 Access Control Lists (IPv6 ACLs)