Show Ip Pim Snooping Interface - Dell Z9500 Command Reference Manual

show ip pim snooping interface

Display information on VLAN interfaces with PIM-SM snooping enabled.
Syntax
show ip pim snooping interface [vlan vlan-id]
Parameters
vlan vlan-id
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
8.3.19.0
8.3.12.0
8.4.1.1
Usage The following describes the show ip pim snooping interface commands
Information
shown in the following example.
Field
Interface
Ver/Mode
Nbr Count
DR Prio
DR
PIM-Sparse Mode (PIM-SM)
(OPTIONAL) Enter a VLAN ID to display information about a
specified VLAN configured for PIM-SM snooping. The valid
VLAN IDs range is from 1 to 4094.
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Description
Displays the VLAN interfaces with PIM-SM snooping
enabled.
Displays the PIM version number for each VLAN interface
with PIM-SM snooping enabled:
• v2 = PIM version 2
• S = PIM Sparse mode
Displays the number of neighbors learned through PIM-SM
snooping on the interface.
Displays the Designated Router priority value configured on
the interface (ip pim dr-priority command).
Displays the IP address of the Designated Router for that
interface.
1395