Dell Z9500 Command Reference Manual page 1685

Hide thumbs Also See for Z9500:

Table of Contents

in | out | both

vlan vlan-id

Debug disabled.

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Service Provider Bridging

Enter one of the following interfaces and slot/port

information:

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

Enter the keyword in, out, or both to debug incoming

interfaces, outgoing interfaces, or both incoming and

outgoing interfaces.

Enter the keyword vlan then the VLAN ID. The range is from

Enter the keyword count then the number of debug

outputs. The range is from 1 to 100.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Introduced on the C-Series, E-Series, and E-Series ExaScale.