Distribute-List Out - Dell Z9500 Command Reference Manual

distribute-list out

To restrict certain routes destined for the local routing table after the SPF calculation, apply a filter.
Z9500
Syntax
distribute-list prefix-list-name out [bgp | connected | isis |
rip | static]
To remove a filter, use the no distribute-list prefix-list-name out
[bgp | connected | isis | rip | static] command.
Parameters
prefix-list-
name
bgp
connected
isis
rip
static
Defaults Not configured.
Command ROUTER OSPF
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1268
Enter the name of a configured prefix list.
(OPTIONAL) Enter the keyword bgp to specify that BGP
routes are distributed.
NOTE: BGP and ISIS routes are not available on the C-
Series. BGP, ISIS, and RIP routes are not available on the
S-Series.
(OPTIONAL) Enter the keyword connected to specify that
connected routes are distributed.
(OPTIONAL) Enter the keyword isis to specify that IS-IS
routes are distributed.
NOTE: BGP and ISIS routes are not available on the C-
Series. BGP, ISIS, and RIP routes are not available on the
S-Series.
(OPTIONAL) Enter the keyword rip to specify that RIP
routes are distributed.
NOTE: BGP and ISIS routes are not available on the C-
Series. BGP, ISIS, and RIP routes are not available on the
S-Series.
(OPTIONAL) Enter the keyword static to specify that only
manually configured routes are distributed.
Open Shortest Path First (OSPFv2 and OSPFv3)