Tunnel Destination - Dell Z9500 Command Reference Manual

tunnel destination

Set a destination endpoint for the tunnel.
Syntax
tunnel destination {ip-address | ipv6–address}
To delete a tunnel destination address, use the no tunnel destination {ip-
address | ipv6–address} command.
Parameters
ip-address
ipv6–address
Defaults none
Command INTERFACE TUNNEL (conf-if-tu)
Modes
Command
Version
History
9.7(0.0)
9.5(0.1)
9.3(0.0)
Usage
The tunnel interface is inoperable without a valid tunnel destination address for the
Information
configured Tunnel mode.
To establish a logical tunnel to the particular destination address, use the
destination address of the outer tunnel header. If you configure a tunnel interface
or source address, the tunnel destination must be compatible.
tunnel dscp
Configure the method to set the DSCP in the outer tunnel header.
C9000 Series
Syntax
tunnel dscp {mapped | value}
To use the default tunnel mapping behavior, use the no tunnel dscp value
command.
Parameters
mapped
1806
Enter the destination IPv4 address for the tunnel.
Enter the destination IPv6 address for the tunnel.
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000 and Z9000.
Enter the keyword mapped to map the original packet DSCP
(IPv4)/Traffic Class (IPv6) to the tunnel header DSCP (IPv4)/
Traffic Class (IPv6) depending on the mode of tunnel.
Tunneling