Dell Z9500 Command Reference Manual page 929

Hide thumbs Also See for Z9500:

Table of Contents

ip ip-address

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

IPv4 Routing

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN, enter the keyword vlan then a number from

(OPTIONAL) Enter the keyword ip then the IP address of the

ARP entry you wish to clear.

(OPTIONAL) Enter the keywords no-refresh to delete the

ARP entry from CAM. Or use this option with interface or

ip ip-address to specify which dynamic ARP entries you

want to delete.

NOTE: Transit traffic may not be forwarded during the

period when deleted ARP entries are resolved again and

re-installed in CAM. Use this option with extreme

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Added support for 4094 VLANs on the E-Series ExaScale

(the prior limit was 2094).

Introduced on the E-Series ExaScale.

Introduced VRF on the E-Series.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.