Show Config - Dell Z9500 Command Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.5.1.0
6.2.1.1
Usage STP is not enabled when you enter SPANNING TREE mode. To enable STP globally
Information on the switch, use the no disable command from SPANNING TREE mode.
Example
Dell(conf)#protocol spanning-tree 0
Dell(config-stp)#
Related disable
Commands no disable command.

show config

Display the current configuration for the mode. Only non-default values display.
Z9500
Syntax
show config
Command SPANNING TREE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
1776
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— disables spanning tree group 0. To enable spanning tree group 0, use the
Description
Introduced on the Z9500.
Introduced on the S4820T.
Spanning Tree Protocol (STP)