Dell Z9500 Command Reference Manual page 1025

To remove the IPv6 route, use the no ipv6 route [vrf vrf-name]ipv6-
address prefix-length {ipv6-address | interface | interface
ipv6-address} [distance] [tag value] [permanent] [weight]
command.
Parameters
vrf vrf-name
ipv6-address
prefix-length
interface
ipv6-address
distance
tag value
IPv6 Basics
(Optional) Enter the keyword vrf followed by the name of the
VRF to install IPv6 routes in that VRF.
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a Null interface, enter the keyword null then the Null
interface number.
• For a tunnel interface, enter the keyword tunnel then
the tunnel interface number. The range is from 1 to
16383.
• For a VLAN interface, enter the keyword VLAN then the
vlan number. The range is from 1 to 4094.
If you configure a static IPv6 route using an egress interface
and enter the ping command to reach the destination IPv6
address, the ping operation may not work. Configure the
IPv6 route using a next-hop IPv6 address in order for the
ping command to detect the destination address.
(OPTIONAL) Enter the forwarding router IPv6 address in the
x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
(OPTIONAL) Enter a number as the metric distance assigned
to the route. The range is from 1 to 255.
(OPTIONAL) Enter the keyword tag then a tag value number.
The range is from 1 to 4294967295.
1025