Ipv6 Address Eui64 - Dell Z9500 Command Reference Manual

ipv6 address eui64

Configure IPv6 EUI64 address configuration on the interface.
Z9500
Syntax
ipv6 address {ipv6-address prefix-length} eui64
To disable IPv6 EUI64 address autoconfiguration, use the no ipv6 address
{ipv6-address prefix-length} eui64 command.
Parameters
ipv6-address
prefix-length
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.2(0.0)
Usage This command allows you to create an EUI64 address based on the specified prefix
Information and MAC address only. Prefixes may be configured on the interface using the ipv6
nd prefix command without creating an EUI64 address.
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
IPv6 Basics
Enter the IPv6 prefix in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Description
Introduced on the Z9500.
Introduced.
1017