Disable - Dell Z9500 Command Reference Manual

disable

Disable the spanning tree protocol globally on the switch.
Z9500
Syntax
disable
To enable Spanning Tree Protocol, use the no disable command.
Defaults Enabled (that is, the spanning tree protocol is disabled.)
Command SPANNING TREE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.5.1.0
6.2.1.1
Related protocol spanning-tree
Commands
forward-delay
The amount of time the interface waits in the Listening state and the Learning state before transitioning
to the Forwarding state.
Z9500
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
1772
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— enters SPANNING TREE mode on the switch.
Spanning Tree Protocol (STP)