Dell Z9500 Command Reference Manual page 1438

ttl_value
drop
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.8(0.0)
9.7(0.0)
9.5(0.1)
9.4(0.0)
9.0.2.0
9.0.2.0
8.3.11.1
8.3.7.0
Usage The monitor command is saved in the running configuration at Monitor Session
Information
mode level and can be restored after a chassis reload.
Example
Dell#show monitor session
IP
---------
1.1.1.1
1.1.1.1
5.1.1.1
Related
show monitor session
Command
show running-config monitor session
monitor session.
1438
IP TTL value of the ERSPAN traffic. The range is from 1 to
255. The default value is 255.
Monitors only the dropped packets in the Ingress.
Description
Added the drop parameter.
Introduced on the S6000-ON. Introduced the set ip
dscp and set ip ttl parameters.
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, and Z9000.
Introduced on the S6000.
Introduced on the MXL.
Introduced on the Z9000.
Introduced on the S4810.
SessID Source
Dest IP
------ ------
--------
0 Te 1/12
7.1.1.2
0 Po 1
7.1.1.2
1 Vl 11
3.1.1.2
— displays the monitor session.
Destination
DSCP TTL
-----------
---- ---
remote-ip
0 255
remote-ip
0 255
remote-ip
0 255
— displays the running configuration of a
Dir Mode Source
--- ----
rx Flow
tx Flow
rx Flow
Port Monitoring